The set is precision-machined from heat-treated alloy steel or tungsten carbide, with flow channels and sizing bores mirror finished. The geometry is optimized for plastic flow, minimising melt shear, pressure fluctuation and melt fracture. It delivers consistent wall thickness, smooth jacket surface and stable concentricity during long-run continuous extrusion.
These dies support three mainstream extrusion modes: pressure, tube and semi-tube extrusion. They fit most common PVC, PE, XLPE, TPU, FEP and other thermoplastic materials. From ultra-thin insulation for electronic hook-up wire to thick outer sheaths for power cables, we tailor the tip-die combination to match your extrusion line, line speed and material formula.
For cable manufacturers, stable extrusion tooling directly cuts scrap rates, reduces frequent adjustments on the crosshead, and keeps surface defects like orange peel, streaks and bubbles under control. All sizes are customizable based on conductor OD, target insulation thickness and your existing crosshead specification.
Key highlights
Matched tip & die set, excellent concentricity control
Polished flow path, low melt disturbance, premium cable surface
Heat & wear resistant substrate, extended continuous running time
Compatible with multiple polymers and extrusion processes
Full custom sizing for single-core, multi-core, flat and special cables
Custom Wire Extrusion Dies
They are normally manufactured according to the finished profile rather than selected from a universal size chart.
A customer can provide:
Technical Drawing → Wire Material → Feedstock Size → Finished Profile → Tolerance → Extrusion Parameters
The manufacturer can then determine:
- Die opening
- Reduction geometry
- Bearing length
- Corner radius
- Die material
- Working insert design
- Outer die dimensions
For irregular or asymmetric wire profiles, a technical drawing is strongly preferred because nominal dimensions alone may not fully define the required die geometry.

FAQ
What are tip and die in cable extrusion?
Tip is the inner core that guides the copper conductor; die is the outer ring that shapes the outer diameter of insulation or sheath. They work as a matched pair.
Which extrusion type should I choose for my cable?
Pressure extrusion is for tight insulation adhesion; tube extrusion suits easy stripping requirements; semi-tube balances adhesion and stripping performance. We will recommend the right structure after you tell us your cable usage.
Can these dies run fluoroplastics like FEP / PFA?
A: Yes. We use special high-temperature resistant substrate and ultra-smooth polishing for fluoropolymer extrusion to avoid sticking.
Why do I keep getting eccentric jacket?
A: It may come from poor concentricity of the tip-die set, worn locating surface, or unstable crosshead assembly. We can provide matching tolerance control and assembly guidance.
Can you make dies for flat cable or special profile cable?
Sure. We custom non-round profiles, flat shapes and special notch structures according to your drawing.
Hot Tags: extrusion dies for wire and cable, China extrusion dies for wire and cable manufacturers, suppliers, factory, Cable Extrusion Dies, extrusion dies, Extrusion Dies for Wire and Cable, Wire and Cable Extrusion Dies, Wire Extrusion Dies


















